I've successfully got my current ASIC Miner Tube running on this network running great and mining away.

NOW ..... I have an older Block Erupter Cube I'm trying to configure....... does anyone know if/how to factory reset this.... I see the button but do I press while its powered on or off ?

I've got my networ running on 192.168.0.1 and I understand the Block erupter comes set at 192.168.1.254:8000 ....... now I've plugged the powered on BE Cube directly into my PC and switched the IPv4 over to reach it at 192.168.1.254 but can't seem to get to setup screen. (Hence why I'm looking for reset info) I'm not sure what the last owner had it configured as.........

I have a stratum pool ready to rock and roll as my new Tube Miner doesn't work with stratums.

Any help / ideas?

It was a PSU ISSUE, It took me this long to convince wifey to buy a Zalman 1250PSU and its chugging away with the settings given to me by philip !!!!!!

Now I've tried my settings from slushies pool and nadda........even tho I use them on other miners,,,,,,,,,

Who can reccd  a good pool with easy setup

I copied these settings from another user who posted, my settings don't mine either, even tho they work on other miners......

I've lower to below stock settings here is a screen shot :  https://www.dropbox.com/s/igf3dr81ok981dd/settings.jpg?dl=0

Can anyone spot anything wrong , its still not mining

I've input your settings, now it boots up and then after about 20secs both it and my 1000watt power supply turn off................... not blaming the settings just reporting......... its on its own circuit so i know its not a power source issue, *bangs head on desk

and yes I'm connected to UART1

yes I see the boards when I press test they all show 0.00 , I only had one connector coming from it to attach the ethernet controller............ the rest were already hooked daisy chained together........

THANKS so much for your ideas, I'll even pay some btc to get this running.

So I got a ASICMiner Tube 800+ GHs from http://www.112bit.com/product/asicminer-tube-800-ghs-sha256-bitcoin-miner-kit/

Had to source my own power adapter for the Ethernet Controller .....no bigs but was "fun"

Now.....I've accessed it thru Chrome and input all my setting and username etc, BUT it does not start mining, just sitting there at 0.00gh

Any ideas?  What info should I give you guys to help out ?

Ian