Show Posts
|
Pages: [1]
|
Would you be able to add Segwit (B2X) on here? Looks fairly profitable.
|
|
|
Just wanted to follow up on B2X being added to X11, you mentioned before you were working on syncing with the network and wanted to see if there were any issues. Thanks!
|
|
|
If you’re looking for more suggestions on X11 coins: Eternity (ENT), Needle (NDC), and Mambocoin (MMB). All currently low difficulty coins.
|
|
|
You guys look busy adding X11 coins, I love it! Other suggestions for X11: Monoeci, Digifel, and DigiMoney. There are some others that seem to be generating noise like Omega and Steep but I don't see any exchanges for them yet.
|
|
|
Hey, I was wondering if it would be possible to add Segwit2x (B2X) to the X11 pool? It still seems to be a high profit coin. Thanks!
|
|
|
Any way you could add Segwit2x (B2X) to the X11 pool? It's been making pretty good profit over the last few weeks. Thanks!
|
|
|
Another higher profit X11 coin (if you can find an exchange) is Segwit2x (B2X), would be good to add
|
|
|
Would you be able to add Polis and Advance to the X11 pool? Both seem to be moving up in profitability. Thanks!
|
|
|
Hi all, still no luck with getting DashGold back on? Was there a blockchain issue?
|
|
|
Glad to see service is restored, I like this site!
I was also wondering about bringing DashGold back to X11, I think the blockchain itself was having difficulties yesterday but it might be back up now?
|
|
|
Hi guys, thanks for making the update that quickly! Just want to check in that that change didn't affect what coins to mine and what not to - it seemed to move away from Dashgold (currently at ~0.8 mBTC/Gh/day) to other coins at much lower profitability...10x less profitability to the next coin. Thanks!
|
|
|
Would it be possible to change the unit of measure for X11 from mBTC/MH/day to mBTC/GH/day for all charts? It would make the graphs and figures more align with other pools like zpool. Thanks!
|
|
|
Was the beta v2.02 not meant to run for any length of time? I ran it for ~10 hours and for some reason my Chain 3 is much worse now in terms of HW failures. I set it on the lowest voltage and before I ran the beta (but ran many different Blissz firmware updates before that) it was fine around 450. Now it can't get above 419 without multiple HW failures per minute. Anyone else experience this?
I'd like to add that I've been very happy with what Blissz has been able to do thus far, so thank you!
|
|
|
|