@taserz: today i want to try one of my S9's to flash to your modded fw and try to squeeze ot 16-17Th with the stock psu.
Can you tell me what temperatures do with this mod, as there is not that much info about it. Will the miner work more efficient and temps stay roughly equal, or will they significantly rise?
I assume the latter, as the extra power should go somewhere...?
Thanks.
Edit:
So, i installed (actually my son did, but hey...) the firmware, and it seems to work.
I put it onto 2 of my miners: one with one defective hashboard, and one that is on my top drawer and one of the coolest miners at 77 celcius as we speak.
The 2-boarder indeed increased quite some at 10.7Th stable@800 and 825Mhz. When set to 850, it drops to 10.3TH. Temp rises, but not able to compare.
The other has been set to 800 also, not tried higher yet, and gets a decent 16.3Th@800Mhz setting, with a temp. increase of 11 deg. reaching 88 celcius.
One thing which i find a bit odd, is that my Awesome miner states 16.3Th, while my pool within 10-20 seconds went to 13Th readout, and further increases by .1Th each 5-10 minutes or so. As we speak it has crawled to 13.8, still not doing better as some of my S9i's (exept according to awesome miner and the actual webbased miner screen.)
All i did so far was setting the frequency.
What are the advised next steps?
Also a few tips/requests if possible:
- Can you make the advanced screen appear just in the manu, instead of url change?
- is there apossibility to set the fan speeds?
- please add in your description how to change the rights of the firmware, not everyone knows Linux that well...
- it would be highly advisable to make a small index of which firmware does what to which miner.
- i find it a little confusing how you set the 2 firmwares in your start post and state both are optimised for S9i (?)
No harm was meant by my comment, just good intentions. I know from expirience that as im not native, sometimes i miss the "subtle way" of writing.