Hi everyone,
I've been reading various posts on the forum relating to antminer gear. I'm aiming to use antminer u2's and a u3 for ease and because I'm just dabbling with it for a bit of fun and "trying my luck" as others have done. I intend to use bitminter pool and connect the U2's to a powered usb hub and run them through the bitminter interface. The questions I have are:-
1) can I run the U3 through cgminer and have it connect to the bitminter pool while I run the U2's through the hub and interface?
2) if I were to swap the U2's out for another U3 could I run it through the same cgminer as the first one or would I need to run two copies of it?
I understand these questions are probably very basic to you all, but I have tried searching through the forum for the answers but I haven't seen a definitive answer, well I probably have but my brain has been bamboozled by all the info.
I will have more questions in time as any newbie does but I will endeavour to find the answers first before I waste all your time
Thanks.