Stripping down Zeus Hurricane X3

[FreeFelix]

Hi All,

Had to replace the power connectors on one of my Hurricane X3.

When taking it apart I failed to notice (silly I know) where the cables for the connecting the 2 blades/boards together.
IN/OUT sockets. There is only one cable

I have tried all the various options and it runs OK until I save and restart the miner then it cuts out. (using the Zeus Rasp Pi controller)

If I don't connect the blades together its runs OK and hashes at about 6.5-7.5 depending on Frequency ie half the hashing power - indication just 1 board is running.
It used to run OK before I had to replace the connectors

Anybody any advice or know the configuration of the wiring

I have looked at my other X3 and it is wired differently maybe an earlier model?

thanks Pete R

[toptek]

on one side about in the middle on the edge of one of the boards is a small min plug for the USB cable it is kind of hard to notice .

 give me a hour or two unless you discovered it or some one beats me to it, I'll post some Screens from one of my Hurricane X 3 boards.

ALSO  you may have hit one of the DIP switches by mistake . I'll post a DIP switch lay out for two boards.






I might make a thunder X3 for fun all i need to make a thunder X3 is another hurricane x3 . i have a old Thunder X6 case laying around with all the parts but the heat sinks and hash boards from the X6 . sense all the boards from all the hurricane thunders etc  X3 or x6 fit all the Zeus cases . i may for fun, if I can find a really cheap hurricane X3 some place.  

[FreeFelix]

Ok thanks any progress

[toptek]

Ok thanks any progress

Sorry got kind of got side track .


I will try in the next Few days to post it .I mostly bitcoin mine now script mining for me is dead kind of i kept all my old script miner and use them from time to time for fun  but trying now to get at least one titan and one or two A2s.

here is the DIP switch lay out i use:


I got this from another post a while back, i just copied it to a note pad file

Board 1: 0 0 0 0
Board 2: 0 0 0 1
 
in your case for the hurricane B1 would be the board not plugged into the USB cable . B2 should be set to 0 0 0 1 . on that board is a small MIN USB  mini pin this cable should fit it . http://www.ebay.com/itm/121592721552?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT to give you a better idea of what to look for till I get time to post Screens of that plug on a hurricane hash board .

[jminer85]

what would be the dip config for a thunder x3

[bigs21024]

Yes anyone have dip switch settings for x3