|
May 02, 2013, 06:52:35 PM |
|
repost from the newbie section because I didn't get an answer there
Hi everybody,
I'm using Electrum 1.7.3 with the gap limit left at the default value of 5. When I look at the receiving tab in the classic GUI it shows me 5 unused addresses, so far so good.
However if I switch to lite mode it lists 9 addresses and those in reversed order (#9 being at the top).
1.) Why the difference? 2.) If I understand it correctly (correct me if I'm wrong) the purpose of having to supply the correct gap limit upon restoring from a seed is that Electrum can basically walk through unused addresses up to the limit to see what has been going on. If I were to use the 9th address from lite mode, but none of the other unused addresses (effectively leaving a gap of 8) and then do a recovery from seed with the gap correctly stated as 5, wouldn't that screw up the recovery?
|