Help with cgminer and an S1 miner....

[fire000]

Right guys hopefully someone has worked out how to do this and can point me on how to go about it.....

What I need help with is how to disable the fallback mode on the s1 ant eg to stop it from looking at pool 0 as the deafult pool and then 1 etc ......    

Long story but is trying to gain control over the ant to allow for a 3rd party bit of software to pool hop....    <<<<<  has been able to get full api access over the ant to allow for remote entering of 100's of pools and can manual change from pool to pool etc but here where I get stuck the remote motioning will not allow me to over write the fall back on the ant....   So for example I could be on pool 20 for example and it will default back to pool 0 after x time due to fall back on the ant.....

Any help to point me where to look in the cgminer conf file to disable the fallback would be greatfully

[-ck]

--round-robin       Change multipool strategy from failover to round robin on failure

[fire000]

--round-robin       Change multipool strategy from failover to round robin on failure

Cool thxs and that is in the init.d/cgminer part of the ant I take it I need to change it rather than the normal conf file