S3 WIFI setup including WWAN static IPs.The info Frotz provided helped and thanks!
I could not connect through my Verizon hot spot but I have it set to static IP so I think this is the problem
and will have to change it to DHCP when I have time and try it.
The S3 did connect to another wireless network.
I followed your instructions but reduced them and included my findings not that all may matter but it worked for me in the following sequence:
1- Starting from a factory-reset miner, log into it through Ethernet plugged directly from your computer to the miner.
Go to WAN and write down all the following addresses under your static IP of 192.168.1.99
Here is the list...
IPv4 netmask:
IPv4 gateway:
IPv4 broadcast:
Use custom DNS servers:
Once you have the above 4 addresses written down...
Go to Network->Wifi, find your AP and connect with it. Then go to Network->Interfaces.
2- Even if LAN has DHCP hit apply and save anyway,
For me this generated a MAC address.
3- Go to WAN and change static IP to DHCP. Hit "Switch Protocol".
NOTE: Leave the bottom portion as it is. Even though it has the box checked for "Disable DHCP Server for this Interface"
Go directly to bottom and hit "apply and save".
Then log in to 192.168.1.99 by a computer connected to the wireless network.
Not through LAN.
Go to WWAN.
Now you can change your IP to a static IP.
Enter the info you copied earlier from your static LAN IP.
Hit "switch protocol" if it shows up;
Then go to bottom and hit "apply and save".
Repeat the procedure for multiple miners with different WWAN static IPs.
Happy WIFI Mining!
MikeMike