Hello everyone
Hard Facts:
Sp35, FW 2.6.14
Since the new FW it is possible to set up Timer settings.
1st Problem) The maximum Voltage is 0,790v to achieve max. TH ("Set your Maximum voltage limit to 0.790 for unlimited or less for under-voltage")
the maximum you can enter in timer settings via GUI is 0,70v. ("0.58 - 0.7 (0 to stop mining)").
Solution: I talked to spondoolies tech support and it´s quite easy to change the 0,70v to 0,79v in crontab via ssh.
BUT
2nd Problem)
Setting timer does not only change max voltage it also changes start voltage and automatically sets it to 0,05v below setted max voltage
So if you set 0,79v in crontab via ssh the starting voltage is automatically 0,05v below --> 0,74v and this is too high! it couses miner not to start!
-> Tech Support can not help
now the QUESTION who can help me with this problem?
Thanx a lot!
try 0.78 v which gives you 0.73 for starting volts if it won't start
try 0.77v which gives you 0.72 for starting volts if it won't start
try 0.76v which gives you 0.71 for start volts if it won't start
try 0.75v which gives you 0.70 for start volts if it won't start
try 0.74v which gives you 0.69 for start volts
Don't argue jsut follow the above instructions.
Most likely it will do one of the last two ones.
Once you discover and determine which one does work. post back.
It is important to know what you can get to work. I think 0.74 and 0.69 will surely work
I think 0.75 and 0.70 may work.
Once we know what works anhd what hash you get and what power you use plus the temp of the gear.
you can decide it doing better then say 0.75 and 0.70 is worth trying to do.