AntMinerS5 SD cgminer_4.9.0 firmware e prestazioni graphs.tar.gz

[marvykkio]

any of you have tried this with cgminer firmware 4.9? proposes NICEHAH says that improves stability and power of antminer s5? you have suggestions? has anyone tried? I currently have the latest firmware of bitmain 15/04/2015
with cgminer 4.8.
thank you all for suggestio ns

[notlist3d]

any of you have tried this with cgminer firmware 4.9? proposes NICEHAH says that improves stability and power of antminer s5? you have suggestions? has anyone tried? I currently have the latest firmware of bitmain 15/04/2015
with cgminer 4.8.
thank you all for suggestio ns

I have tired the C1, and S4 ones.   They worked for me if you read instructions.  I ended up going back to a official firmware.   Did not try it on my S5.

Does it work with nicehash yes, but you lose your warranty if still has it.  It was nicely done in my opinion, but it is not an official firmware.

[marvykkio]

thanks for the reply, I remain with the official firmware

[Rockett0]

i tried on 2 S5's. worked fine on westhash when the rate is high enough, but when it fails over to pool 2, the hash rate is about 100 lower than stock firmware.

I reflashed to stock, as I rarely have my S5's on westhash. I had to remove the #xnsub from the URL line after re flashing.

[notlist3d]

i tried on 2 S5's. worked fine on westhash when the rate is high enough, but when it fails over to pool 2, the hash rate is about 100 lower than stock firmware.

I reflashed to stock, as I rarely have my S5's on westhash. I had to remove the #xnsub from the URL line after re flashing.

You might check over in nicehash thread or with smit.  But I think there is something that was wrong at one time with it going when it tried to switch from the main pool (I was thinking it did not do it right).   But I could be wrong.  Someone please correct if your remember whole thing.