|
Epicblood (OP)
|
 |
October 17, 2012, 11:12:26 PM |
|
Hey all, this is due to the aftermath of this threadI plug everything back in, hit the power button and now my fans move about half a cm and then nothing happens. dafuq did I do? |
|
|
|
|
|
|
|
|
|
|
|
|
The forum was founded in 2009 by Satoshi and Sirius. It replaced a
SourceForge forum.
|
|
|
Advertised sites are not endorsed by the Bitcoin Forum. They may be unsafe, untrustworthy, or illegal in your jurisdiction.
|
|
|
01BTC10
VIP
Hero Member
 Offline
Activity: 756
Merit: 503
|
|
October 17, 2012, 11:20:02 PM |
|
Any POST?
If not unplug everything. Then try booting with only one stick of ram if you get a valid POST then add the other stick if any. Then plug one component at the time an try to boot.
Good luck.
|
|
|
|
|
|
Epicblood (OP)
|
|
October 17, 2012, 11:20:45 PM |
|
POST?
|
|
|
|
Remember remember the 5th of November
Legendary
Offline
Activity: 1862
Merit: 1011
Reverse engineer from time to time
|
|
October 17, 2012, 11:21:31 PM |
|
POST-Power-on self test.
|
BTC:1AiCRMxgf1ptVQwx6hDuKMu4f7F27QmJC2
|
|
|
mufa23
Legendary
Offline
Activity: 1022
Merit: 1001
I'd fight Gandhi.
|
|
October 17, 2012, 11:23:10 PM |
|
So why did you start another thread?
|
Positive rep with: pekv2, AzN1337c0d3r, Vince Torres, underworld07, Chimsley, omegaaf, Bogart, Gleason, SuperTramp, John K. and guitarplinker
|
|
|
01BTC10
VIP
Hero Member
Offline
Activity: 756
Merit: 503
|
|
October 17, 2012, 11:23:41 PM |
|
POST?
http://en.wikipedia.org/wiki/Power-on_self-testIf you get 1 short beep when powering up, everything is good else you got a problem. Refer to your motherboard user manual for beep diagnostic code. |
|
|
|
|
|
Epicblood (OP)
|
|
October 17, 2012, 11:24:21 PM |
|
no beep
I'll take out GPU an shit, and see what happens
|
|
|
|
|
SysRun
|
|
October 17, 2012, 11:27:55 PM |
|
Probably one of your GPUs. Unplug them all from the MB then plug one in and make sure you see monitor output. repeat as needed.
This happened to me a few weeks back. It turns out my Power supply was failing out of a lead.
|
Images are not allowed. As your member rank increases, you can use more types of styling in your signature, and your signature can be longer. See the stickies in Meta for more info.
Max 2000; characters remaining: 1781
|
|
|
|
Epicblood (OP)
|
|
October 17, 2012, 11:30:04 PM |
|
Removed my GPU, still nothing, I think i fried my MB
|
|
|
|
|
superfastkyle
|
|
October 17, 2012, 11:36:35 PM
Last edit: October 17, 2012, 11:50:13 PM by superfastkyle |
|
The fans spinning for a fraction of a second is almost always either a bad motherboard or a short wire somewhere.
Here is my troubleshooting procedures.
1. Unplug everything! Remove all cards
2. Check cpu/memory seated properly
3. Cycle switch on power supply, plug back in 24 pin motherboard/8 pin CPU/CPU FAN
4. plug in power switch on motherboard and check that it powers up (if not try different power supply and retry, if still no power replace motherboard)
5. plug in video cards 1 at a time and pcie cables (check pcie adapter cables if used sometimes pins come out of the molex side)
6. Check for power after each video card is added (if no power after a video card is added test motherboard again with just that video card or another system if possible to double check card is dead
7. plug back in drives and boot up system
#1 is important, unplugging cables will reset protection modes on power supply
|
|
|
|
|
PuertoLibre
Legendary
Offline
Activity: 1834
Merit: 1003
|
|
October 17, 2012, 11:37:34 PM |
|
Removed my GPU, still nothing, I think i fried my MB
Whatever you do, don't panic. Disconnect all power leads except for those connected to the motherboard (24pin plus any extra 4 pin plugs). As strange as it sounds, sometimes a fan might fail and it shorts causing strange behavior throughout the system. (Including no POST) If you pull out all cards and leave the system as if it were a barebone, then you should know if it is the motherboard. Also retrace the steps you might have done in the last 24 hours. Usually it might be something pligged in badly. |
|
|
|
|
|
Epicblood (OP)
|
|
October 17, 2012, 11:40:20 PM |
|
unplugged everything, took out GPU and RAM, still nothing...
|
|
|
|
01BTC10
VIP
Hero Member
Offline
Activity: 756
Merit: 503
|
|
October 17, 2012, 11:45:52 PM |
|
unplugged everything, took out GPU and RAM, still nothing...
You need a minimum of 1 stick of RAM to boot  |
|
|
|
|
|
Epicblood (OP)
|
|
October 17, 2012, 11:46:45 PM |
|
well yea, hang on, I'll take a pic of what I have plugged in ATM
|
|
|
|
|
|
|
SysRun
|
|
October 17, 2012, 11:59:56 PM |
|
Try this, (*maybe someone else already suggested this) unplug your power supply from the wall and then remove your CMOS battery. leave it for a few minutes. put the CMOS back in and power back up.
Do you know the model number of your motherboard? some models don't beep when they POST.
|
Images are not allowed. As your member rank increases, you can use more types of styling in your signature, and your signature can be longer. See the stickies in Meta for more info.
Max 2000; characters remaining: 1781
|
|
|
|
SysRun
|
|
October 18, 2012, 12:01:45 AM |
|
wait... how many GPUs on this rig? you only have one? do you have any other GPUs to test with?
|
Images are not allowed. As your member rank increases, you can use more types of styling in your signature, and your signature can be longer. See the stickies in Meta for more info.
Max 2000; characters remaining: 1781
|
|
|
|
Epicblood (OP)
|
|
October 18, 2012, 12:03:43 AM |
|
just the one
its a GA-X58A-UD3R
|
|
|
|
|
superfastkyle
|
|
October 18, 2012, 12:04:35 AM |
|
Epicblood go down my list and tell me where you get stuck and I will be glad to help you. You may get bombarded with replies here and doing them in the incorrect order may not tell us for sure what the issue is
|
|
|
|
|
|
Epicblood (OP)
|
|
October 18, 2012, 12:07:23 AM |
|
Epicblood go down my list and tell me where you get stuck and I will be glad to help you. You may get bombarded with replies here and doing them in the incorrect order may not tell us for sure what the issue is
I have tried everything short of replacing parts (don't have any extras) |
|
|
|
|
