here is the setting up of the fan power supply pcie cables from finksy with 1 end for the 2880/2980 breakout board.
I left out stripping the wires
yellow is pos goes to red on the fan jacks
black is neg goes to block on the fan jacks
one wire is 16 awg it can carry 80 watts so 1 wire for 2 fans is much more then needed as these 2 fans only pull 25 watts
vs 60 watts for the oem screamers
note I folded the extra wires back and taped them off
these twist nuts will do yellow or orange
the connected 3 pin fan jacks.
wtf is this for ?
black tape + short protection and strain relief
red tape more short protection and strain relief
assembled and would work at this point
so that does what?
and we tear some tp off the roll and stuff the tube? on both ends
I left you all hanging with this shot some one ask me what is next?