I'm Set up follow the example, But i do not Successful ""Avalon6"""

[notlist3d]

I know why my machine is not working, Conclude  That i use to wrong firmware

anyway, THANK YOU VERY MUCH  for all your advice everyone 

is it working now?

Sounds like it.  OP when you say wrong firmware was it wrong Image on PI you were using?

Out of curiosity which image were you using?

[mc162BCT]

I checking  it's all ok
                
                *4 pin cable,  
                *jack to plug in 4 pin cable
                *little adapter with blue light
                *usb cable from little adapter
                *bad usb jack in the rasp pi

Rasp pi and SD card, i testing remove program and install  on this it's alright    

but I'm not sure the software or wrong set up software  

are you in the USA?  Near New Jersey?

I could test it on my setup if you are close to me.  

I would hook it to these below
https://i.imgur.com/iKC9tIT.png

Im in NJ and have been suffering from this exact issue (blinking red light) no fan activity whatsoever failure to boot etc...

Would your offer still be available?

If so I'd be happy to compensate you for your time and whatever help you might be able to provide (Central NJ BTW)

Let me know ;-)

[philipma1957]

I checking  it's all ok
                
                *4 pin cable,  
                *jack to plug in 4 pin cable
                *little adapter with blue light
                *usb cable from little adapter
                *bad usb jack in the rasp pi

Rasp pi and SD card, i testing remove program and install  on this it's alright    

but I'm not sure the software or wrong set up software  

are you in the USA?  Near New Jersey?

I could test it on my setup if you are close to me.  

I would hook it to these below

Im in NJ and have been suffering from this exact issue (blinking red light) no fan activity whatsoever failure to boot etc...

Would your offer still be available?

If so I'd be happy to compensate you for your time and whatever help you might be able to provide (Central NJ BTW)

Let me know ;-)

Sorry I missed this yesterday.   I may be able to help you  send me a pm.

did you ever have it work?