Thanks for getting me in on this Phil. Hello all.
If you ever need anything instantly just text me. For a new miner to play with I will always answer immediately haha.
Phil, I would always get with you right away.
(By the way there is a list of addresses where you can text from your PC for all of the Cell Carriers on ZachM's Kano.IS CKPool site.)
I've wanted this Avalon miner but the cost was not working on paper, until I added a couple of other variables. The cost of RMAing parts with a-nother manufacturer has cost which must be factored in, time spent with hashboards going back and forth, time spent with hashboards going back and forth, time spent writing e-mails to go through 4 phases of life trying to get help, polite, stern, upset, pleading, passing out
Any tips for a new Avalon 6 user? I also haven't played with a pi, but I've played with all sorts of other similar components and I can scrape by in Linux. I do well when copying and pasting someone else's commands.
Where is the best underclock thread?
How are the failure rates? Anything special I should look out for when looking under the hood?
I checked the support section but didn't find the right manual yet. I'd like to see manufacturer specifications for power. Do you think this unit will be 1200?
Thanks all
I think it will use 1100 watts to do about 3700gh
So if you are a 120 volt guy the evga 1300 is pretty much spot on to run this gear.
Suggestions gear the room under 92f I am setting my freq at 500 with my fans at 45%
My temps are steady at 66c the room is about 82 f
don't get the room really hot don't over volt.
Every fail has been running boards with high volts 3 separate boards burned
at high volts like 12.7 or 12.8 input volts.
@ every one in on this buy I did not get the shipping info as of 1 am I am going to crash.
Yan should post them via pm to me on sat or sun