A2 wiring

[usao]

Bought A2, didnt work.
Did some exploring and found the PI has no power cord.
Does anyone know where the cable is supose to connect to the source? I think I will have to make a cable, but dont know where it goes on the A2 side.

[1715073462]

1715073462

[1715073462]

1715073462

[1715073462]

1715073462

[mjgraham]

the pi gets power backfed from the controller board via the ribbon cable, trust me if gets hooked up backwards things don't make it.,Does it have an atx supply?
just a couple of checks, pull the pi out and see if it works normally, also when you turn on the power do the fans come on?

[usao]

Ok then, yes the fans run. i already pulled the pi and booted it with HDMI so I could find the IP.
For unknown reason its IP address wasnt even in my network.
I setup a static IP and was re-installing the PI when I got confused by the lack of the micro-USB cable I normally see on a PI.
Ill continue to setup and see if I can get it going now that it has the static IP assigned.

[mjgraham]

like I said be dang sure the ribbon cable goes back in right or the pi doesnt make it

[usao]

Thanks for the help. Its mostly working now. Got 70 MHs...

[mjgraham]

no problem I started about like you did, except I just had two has boards and got them working , was your a 110 or a 90 version?

[usao]

Its an 88, but only 5 working boards.

[mjgraham]

on the board that doesn't work have any LEDs on it and if so what are they doing? I am guessing there blue boards?