ADVICE - How to i make set of PCI-e leads for IBM Bladecentre H Chassis 2880w ??

[bilabonic]

Hi All

Managed to get my hand on x2 to of these Server PSU's, but not sure best way to connect them, i plan on running one or even two Antminer S7's or two S9's of each PSU -

http://www.ebay.co.uk/itm/282145655675?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

I have SEARCHED the forum and seen a seller who does a 'J4bberwock Mods Breakout Board' for this PSU but have not had response to his thread or PM.

Has anyone done this ? Made their own leads with either x20 or x10 6 pin PCI-e outputs from the PSU ??

Looks like you need 16 AWG wire and the 6 pin PCI-e plugs ??

Anyone help me  please ?

Thanks 

[bilabonic]

Anyone help here please, can't find how to connect them ? or what the pin connections are ??

Someone MUST have converted these 2880w PSU's !!







I presume the 6 connections on the left are the +12v and the 6 connections on the left are Negative.

I can NOT fins a pin layout for the centre pins to remote switch it on or the best way to connect 10 or even 20 PCI-e cables

Thanks

[HagssFIN]

Check this out:
https://bitcointalk.org/index.php?topic=966135.0

I would suggest to get a breakout board.

[bilabonic]

Check this out:
https://bitcointalk.org/index.php?topic=966135.0

I would suggest to get a breakout board.

Cheers mate, missed that !!!!

[HagssFIN]

No problem 

[Finksy]

Thanks for the referral 

I don't have the pin out handy, but I do have a friend who was wiring the PSU'sma sully with high end soldering /ultrasonic welding equipment before he boards came along. He said it wasn't worth his time/cost to do it himself over buying the boards. His post is on one of the ibm 2880w threads.

Have you tried getting ahold of J4bberwock on this forum yet? He's the developer of the board and based out of EU.

[bilabonic]

Thanks for the referral 

I don't have the pin out handy, but I do have a friend who was wiring the PSU'sma sully with high end soldering /ultrasonic welding equipment before he boards came along. He said it wasn't worth his time/cost to do it himself over buying the boards. His post is on one of the ibm 2880w threads.

Have you tried getting ahold of J4bberwock on this forum yet? He's the developer of the board and based out of EU.

Thanks for the reply...

I will message J4bberwock, i thought he was based in France, in the EU ?

Cheers