INNOSILICON A4 DOMINATOR SETUP GUIDE ---REVAMPED

[kayson2]

Hi everyone,

My A4 meet this issues 1 ASC is not working, detail in picture:
https://ibb.co/cNLKT6

How can i fix it?
Thanks you

[KingWilly]

Did anyone tinker with the settings yet ?!

I'm looking for a way to under/over clock these A4's (280mh version) to get a better w/mh
at the moment i'm stuck at 3,2 w/mh at the lowest..  (700v - 800mhz)

also, innosilicon used a custom cgminer version for there dominators but did not released the sourcecode.
(But hey, cgminer is released under gpl-v3 !!, gimme the source!)

what i'm looking for are the most optimal settings (A1pll and A1vol)

Cheers.

[KingWilly]

Dose anyone know how to enable API access?

You mean the API of cgminer ?!
try cgminer /? 

if i'm correct: --api-listen --api-network

[KingWilly]

Does someone know how to use the --CS switch of cgminer ?!

i can only use --CS 8 (for all blades) or only 1 blade (--CS 1, or --CS 2, ect ect)

i'de like to use 2 blade, and the other 2 blades on a different cgminer instance.
so u think --CS 1,2 would work... but i doesn't.

any help appreciated !

[ip977]

Does anybody have new firmware for dominators ?
or some setting to save electricity ?

ThX

[vinylwasp]

Does anybody have new firmware for dominators ?
or some setting to save electricity ?

ThX

Just drop your voltages until they stop working for each speed.
I run 3 units connected to a single controller at 900Mhz/730Mv and get 310Mh/s at 920 Watts.