I can't login to my antminer

[condourfx]

Hello,

I have problem in my S9 antminer . I can't open the configuration page like this : http://192.168.1.33/index.html
I try open it in several browsers and I do reset for it also I can't opened it .
note that it work and connected normally and the other antminer work good

How can resolve this problem ?

Thanks

[BigBoom3599]

Could you give us some more information?
What does it say when you try to open the page?
What have you tried?
Are you sure that you're on the same LAN?
Are you sure that 192.168.1.33 is the correct IP address, if not you might want to set a static IP for your miner in your router's config.

[gt_addict]

The S9 is set to DHCP as a default. You will need to run IPScanner or similar program to find what address the S9 is using. Then just log into it.

192.168.1.33 is what bitmain used to set the old S3 miners to. It's not the case anymore.

[m4rv3]

Hello,

I have problem in my S9 antminer . I can't open the configuration page like this : http://192.168.1.33/index.html
I try open it in several browsers and I do reset for it also I can't opened it .
note that it work and connected normally and the other antminer work good

How can resolve this problem ?

Thanks

192.168.1.33 may not be the up address of your miner,  you need to ran the ipscanner program found in the manual to find your iP address...  Or you can also use any other ip scanner program available on the Internet.  

[mr.bitcoinerf11]

contact support for help

[VRobb]

Login to your router and check the logs - you'll see where it's connected (assuming a different IP address is indeed the problem).

[gt_addict]

This was 14 days ago and no response from OP. I think someone was trying to get their activity up a notch by dragging this thread back up lol

[I can break these cuffs]

for future people that will have this issue :
your dhcp probably got changed, refresh your router's page or download this https://enshop.bitmain.com/support.htm?pid=00720160906053730999PVD2K0vz0693     make sure your computer is connected to the same router that the machines are connected to in order to use that program. click the big start button then hold the ip check button on front of the miner(which should be the only button you can press) for about 5 to 8 seconds then an ip address page will appear. If you're still getting this problem then get a paperclip and hold down the reset button I'd say for 10 secs max.