Help with Antminer S9 HW errors (numbers)?

[sarakuka]

Hello I'm a new miner in need for some suggestions from more experienced miners.

I have two Antminer S9 11.85/Ths and 13/Ths but they have so many HW that I understood HW is for errors count number.

The room is very clean there is no dust the temp is like 10C all the time.

I will upload the screenshot of my Antminers errors please advice.

Antminer S9 13/Ths


Antminer S9 11.85/Ths



I will upload the screenshot of the status of the Antminers to see if the latest and correct firmware is installed.

Antminer S9 13/Ths status.


Antminer S9 11.85/Ths status.



Thank you

[philipma1957]

Hello I'm a new miner in need for some suggestions from more experienced miners.

I have two Antminer S9 11.85/Ths and 13/Ths but they have so many HW that I understood HW is for errors count number.

The room is very clean there is no dust the temp is like 10C all the time.

I will upload the screenshot of my Antminers errors please advice.

Antminer S9 13/Ths


Antminer S9 11.85/Ths



I will upload the screenshot of the status of the Antminers to see if the latest and correct firmware is installed.

Antminer S9 13/Ths status.


Antminer S9 11.85/Ths status.



Thank you

okay they should show

your photos do not show as they are oversized shrink them to 1200 x 1000
I did fix one and I circled the important number

so for every 100.0000%   you are losing 0.0008%

the hw gets big    cause the gear mines fast.

if that number goes from 0.0008% to   0.0300%

 you may need :

 1) better psu
 2) cooler room

I assume you have an autotune s9
since you have an autotune GUI

[ANTZ25]

why on the 11TH appears fan 6 with 15.120 rpm?

[sarakuka]

why on the 11TH appears fan 6 with 15.120 rpm?

I don't know should I be worried? What should i look at.

This my status of the fan on my 11TH atm.

             Fan#   Fan1   Fan2   Fan3   Fan4   Fan5   Fan6   Fan7   Fan8
Speed (r/min)   0   0   4,680   0   0   10,200   0   0

Thanks

[ANTZ25]

why on the 11TH appears fan 6 with 15.120 rpm?

I don't know should I be worried? What should i look at.

This my status of the fan on my 11TH atm.

             Fan#   Fan1   Fan2   Fan3   Fan4   Fan5   Fan6   Fan7   Fan8
Speed (r/min)   0   0   4,680   0   0   10,200   0   0

Thanks

I don't know, never seen any thing like that, if you invert the fan connectors does show the same reading? I don't think there's a mayor problem but I notice the temps on the 13th one are lower than the 11th one.