Ethos claymore.stub.conf for Zpool

[Sorude]

Hi

So I'm having a few frustrating issues.

Been mining a short time and now want to dual mine ETh and DCR. 

Eth is going well but for the life of me I can't get DCR working (had Sia working).

Now the reason I want to use zpool is so it's a set and forget and get paid in bitcoin.  If there is a better option then I'm all ears but this is my plan.  I did try suprnova but I couldn't get that working either.

Now before I go through the process of messing with my miner again and constantly rebooting as I'm getting the dual mining wrong could someone help me with my config, should this work?

Any help would be great.

# WARNING! Remove "#" characters to enable lines, with "#" they are disabled and will be ignored by miner! Check README for details.
# WARNING! Miner loads options from this file only if there are not any options in the command line!
-colors 1
-dbg -1
-esm STRATUMTYPE
-epool POOL1
-ewal WALLET
-epsw PASSWORD1
-eworker WORKER
-allpools 1
-gser 2
-allcoins 1
-wd 0
-tt -70
-dcri 20

#uncomment and configure the -dpool and -dwal lines below to enable dualmining.
-mode 0

#-ewal 0xD69af2A796A737A103F12d2f0BCC563a13900E6F
#-epsw x
#-dpool stratum+tcp://yiimp.ccminer.org:4252
-dpool stratum+tcp://decred.mine.zpool.ca:5744
-dwal 35eyAY8nRbqpgMNvkC7brGWnyDWBh1XZXS
-dcoin decred
#-dpsw x
#-esm 1
#-mode 0
#-tt 70

[harmach]

-dcoin decred

swap to -dcoin dcr

insert -dcri 15~25 (adjust to power on 2nd coin)

insert -mode 0

insert -dpsw x (or password that matches )

[Sorude]

Thanks

I wasn't sure if I had my -dpool set up right but I'll try this config tomorrow (too busy at my day job)