Antminer L3+: HW errors...

[Shitcointalk]

Hi, i am new here with s9. Is these stats ok? running for over 24hours now, had couple of times lost internet connection.
Thanks

https://imgur.com/a/qxOsR

Too much HW on board one, but not that bad either. Chip temp is a little higher, but I believe S9 can run hotter than L3+.
Just try to exchange PCI, and PSU. Maybe give a try to another pool. It is also good to clean the dust inside about once a month. Last thing, reduce the frequency a little.

Maybe some expert will give you better advice. Do not hesitate to ask bitmain as well.

[1713578836]

1713578836

[1713578836]

1713578836

[Shitcointalk]

I too am randomly having issues with the S9 and HW errors and sudden skyrocketing of hash rates and then down to nothing and then back again. I am hashing correctly with the pool at 14ths so it is working correctly I am worried about longevity. https://imagebin.ca/v/3kla6B3aXgbb

You have a problem with board 2. Way too much HW. It does affect your hash rate, and might be a sign a short life expectancy for this board. Do you have a modified FW to have different frequency per chains ?

[Shitcointalk]

I have done nothing to the firmware except upload the newest version. I am getting an accurate hashing rate and payout from the pool though.

Interesting, must be specific to S9. Not sure where your HW come from. Maybe you can lower the frequency a little and see if it is any better.
You should try to contact bitmain while you wait for better answer.

[Shitcointalk]

Just FYI for you all the miner just stopped working 30 minutes ago. I bought this miner off amazon and have arranged for a refund. Done with BTC gonna look at ALT coins!

Good you can get a refund. You never know how and how long the miner has been used when buying a second hand. Always better to buy directly from bitmain, you get a new product plus warranty at the best price.

[accumulusminers]

Hardware error just happen and are a totally normal part of mining. It is not uncommon to see one board with a bunch more than another, it might have a weak component somewhere. Unless you are seeing 10-100x the errors on one board versus the others I really wouldnt worry about it too much. In the end, there is literally nothing you can do to fix it unless maybe you have a firmware that allows you to underclock the boards.

So on my antminer they are called chain #x  one has 35 the rest have all zeros.  so that's infinity x do I worry?

[Airdisganne]

Hi,


I have it working at 450 with only one CPU making some error (the rest 0 HW) with only 10 HW.

I think works fine.

Any advice?

 

[philipma1957]

good numbers no worries see below

[TheYankeesWin!]

So phil  you have a HW rate of 0.0131%

That would mean    99.9869%  is good.

In other words  if you have enough to earn 10,000.00 usd    the errors would drop you to $9998.69

a $1.31   loss for every $10,000.00 earned correct?

[philipma1957]

@ yankees yes that math is correct.

I try to keep  my L3+  at 0.0500 or lower

which means  of every 10,000 usd I earn I lose 5 usd to errors.