Guys,
Is this wiring correct (pic below)? Right now, LED1 is yellow, LED2 is green. I have two running daisy chained together into the Avalon controller. They've been running, but every 20 minutes or so, one psu shuts down and all LEDs go to yellow.
https://www.flickr.com/photos/152844983@N06/37493504356/in/dateposted-public/Just to explain the pic a bit more, each set of 3 PCI-e cables goes to a separate card on the Avalon 741.
Thanks,
Steve
what volts are you using?
that psu does 900 watts at 120 volts
it does 1200 watts at 240 volts.
my suggestion is for you to lower your VOLTS IN THE GUI
try 0 if you are at +1 almost no one gets good results at +1
try -1 if you are at 0
try -2 if you are at -1 >>>>> I am running at -2 to keep noise down