Bitcoin Forum
May 17, 2024, 08:17:47 PM *
News: Latest Bitcoin Core release: 27.0 [Torrent]
 
   Home   Help Search Login Register More  
Pages: [1]
  Print  
Author Topic: What's the max length exhaust hose?  (Read 287 times)
MedvedTrader (OP)
Newbie
*
Offline Offline

Activity: 25
Merit: 1


View Profile
December 06, 2017, 05:50:18 AM
 #1

If I use 5" exhaust hose for an S9, what's the max length that the fan can push through without causing problems? The hose will make a 90 angle and go straight up...

Basically, what I want to do is to run it in the garage, have the hose move the hot air to the garage attic and have the 1000 CFM gable fan blow the hot air outside. Feasible?
gt_addict
Hero Member
*****
Offline Offline

Activity: 2492
Merit: 621


View Profile
December 06, 2017, 09:44:59 AM
 #2

2 or 3 metres tops. Always best to have an inline fan sucking there air out aswell.

**SUPPORT SIDEHACK** Miner Development Donations to:  1BURGERAXHH6Yi6LRybRJK7ybEm5m5HwTr

Donations/Tips to:-   1GTADDicTXD1uachKKgW24DZDxDGhSMdRa

Join Bitconnect: https://bitconnect.co/?ref=gtaddict
MedvedTrader (OP)
Newbie
*
Offline Offline

Activity: 25
Merit: 1


View Profile
December 06, 2017, 02:58:55 PM
 #3

Ok what is a good, reasonably priced high CFM inline fan?
gt_addict
Hero Member
*****
Offline Offline

Activity: 2492
Merit: 621


View Profile
December 06, 2017, 03:58:13 PM
 #4

Ok what is a good, reasonably priced high CFM inline fan?

All depends what country you are in, what noise levels are acceptable etc.

**SUPPORT SIDEHACK** Miner Development Donations to:  1BURGERAXHH6Yi6LRybRJK7ybEm5m5HwTr

Donations/Tips to:-   1GTADDicTXD1uachKKgW24DZDxDGhSMdRa

Join Bitconnect: https://bitconnect.co/?ref=gtaddict
MedvedTrader (OP)
Newbie
*
Offline Offline

Activity: 25
Merit: 1


View Profile
December 06, 2017, 05:09:32 PM
 #5

USA, noise - well, as long as it is not louder than the S9 Smiley But obviously quieter the better.

This one looks good no? https://www.deelat.com/hvac/fans/ventilation-air-fan-blowers-and-movers/portable-exhaust-fan-ventilation-diameter-8-200-mm-single-phase-110v
Didley1JT
Full Member
***
Offline Offline

Activity: 140
Merit: 100


View Profile
December 07, 2017, 01:32:52 PM
 #6

Is the 90 degree turn the total change in direction (over a long distance) or are you coming straight from the miner with a 90 degree elbow?

Limit the bends in the duct as much as possible, since each bend represents a then higher fan requirement. If you need to turn 90 degrees, do it gradually and avoid sharp angles.

BTC: 1GaqNkHcstajEex6LQ6caMDLNJMLKwourJ
Steamtyme
Legendary
*
Offline Offline

Activity: 1540
Merit: 2036


Betnomi.com Sportsbook, Casino and Poker


View Profile WWW
December 08, 2017, 05:03:34 AM
 #7

I noticed you said you are going to send the exhaust up to the attic. What is your setup in the attic, if you can set your miners up in the attic pointing towards the exhaust fan you wont have to worry about ducting.

If you are going to go with the ducting route, here was a thread that came up with some good solutions.

https://bitcointalk.org/index.php?topic=2258553.msg22887057#msg22887057


░░░░░▄▄██████▄▄
░░▄████▀▀▀▀▀▀████▄
███▀░░░░░░░░░░▀█▀█
███░░░▄██████▄▄░░░██
░░░░░█████████░░░░██▌
░░░░█████████████████
░░░░█████████████████
░░░░░████████████████
███▄░░▀██████▀░░░███
█▀█▄▄░░░░░░░░░░▄███
░░▀████▄▄▄▄▄▄████▀
░░░░░▀▀██████▀▀
Ripmixer
░░░░░▄▄██████▄▄
░░▄████▀▀▀▀▀▀████▄
███▀░░░░░░░░░░▀█▀█
███░░░▄██████▄▄░░░██
░░░░░█████████░░░░██▌
░░░░█████████████████
░░░░█████████████████
░░░░░████████████████
███▄░░▀██████▀░░░███
█▀█▄▄░░░░░░░░░░▄███
░░▀████▄▄▄▄▄▄████▀
░░░░░▀▀██████▀▀
Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2006-2009, Simple Machines Valid XHTML 1.0! Valid CSS!