GPU found incorrect share... HELP please

[skynetcoin]

I have 3 GPUs and all of them RX 460 4GB. I'm using claymore 10.2 . Although i didn't manuel overclock i sometimes get this error ( gpu0 found incorrect share. if you see this message often, make sure you that you did not overclock it too much, also try to reduce "-h" value. ) GPU0,GPU1 and GPU2

2 cards are MSI rx 460 OC version and other one is Asus ROG rx 460 OC version.

what can i do ??

[m1n1ngP4d4w4n]

Lower your overclock, change your bios timing if you tweaked it, check out your riser.

But if it's a rare occurence it's ok, it happens, goes with it.

[dragonmike]

Strangely enough, I upgraded both my RX 570 rigs to the fall creator update, then DDU'd the August blockchain drivers and reinstalled them... and all I'm getting upon restarting Claymore is a whole screenful of these errors (and nothing else). On both rigs. Note that nothing's changed in my settings, clocks or voltages. It should basically just pick up where it left off... but no. -.-

EDIT: A couple of reboots and miner restarts later and everything works fine again. Go figure!