Hi,
There is a strange behavior.
After rig was running for less than two hours I noticed that the monitor was off. There was no response on clicking mouse. When clicked on keyboard the GPUs fans started spinning but nothing on monitor. After couple of minutes there was a message that Windows 10 encountered error and will restart. After restart Claymore got executed but GPU0 showing 0 hash rate and the miner got stuck on POOL/SOLO version.
GPU0 status: t=60C fan=53%
GPU1 status: t=54C fan=52%
Did hard reset and after that things got normal.
Any idea/clue about this strange behavior?
Looking forward and thanking you in anticipation.
Regards,
Rizwan
Can you tell us what GPUs are you using? Are they over or under clocked? Did you modify the BIOS (AMD cards)? What kind of PSU are you using?
And finally, post your Claymore BAT file you are using.
Hi,
GPU = 2x RX 580 (factory Overclocked)
BIOS modifications = No
PSU = Corsair HX1200i
BAT file:setx GPU_FORCE_64BIT_PTR 0
setx GPU_MAX_HEAP_SIZE 100
setx GPU_USE_SYNC_OBJECTS 1
setx GPU_MAX_ALLOC_PERCENT 100
setx GPU_SINGLE_ALLOC_PERCENT 100
EthDcrMiner64.exe -epool eth-asia1.nanopool.org:9999 -ewal 0xWALLET_ADDRESS -epsw x -mode 1 -allpools 1