staraptor (OP)
Newbie
Offline
Activity: 45
Merit: 0
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 07, 2011, 02:05:12 AM |
|
Could you guys with 4 cards in one sys post your power draw at the wall along with what cards you have
|
|
|
|
jme621
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 07, 2011, 02:37:33 AM |
|
Could you guys with 4 cards in one sys post your power draw at the wall along with what cards you have
which cards?
|
|
|
|
faille
Newbie
Offline
Activity: 38
Merit: 0
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 07, 2011, 02:44:52 AM |
|
4 x 6950 on an i5 2500k = 820 from the wall
|
|
|
|
trentzb
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 07, 2011, 02:56:58 AM |
|
4 x 5850 on Sempron = 620W at wall / 1400 Mh/s
|
|
|
|
sethmo
Newbie
Offline
Activity: 24
Merit: 0
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 07, 2011, 03:36:16 AM |
|
4 x 5850 on Sempron = 620W at wall / 1400 Mh/s
Cool, I will have two setups of 4 5830s on Corsair 750psu, was worried that I would be getting close to the limit of my psu. Should be good ![Smiley](https://bitcointalk.org/Smileys/default/smiley.gif)
|
|
|
|
trentzb
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 07, 2011, 05:22:08 AM |
|
Careful, those numbers are not stock. Highly tweaked. Same rig not tuned running ~350 Mh/s pulls closer to ~800W at wall. 5830s usually pull a bit more than 5850s.
|
|
|
|
faille
Newbie
Offline
Activity: 38
Merit: 0
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 07, 2011, 05:58:36 AM |
|
don't forget to factor in your PSU efficiency, and try to leave a little headroom on top if you can.
|
|
|
|
newunit16
Member
![*](https://bitcointalk.org/Themes/custom1/images/star.gif)
Offline
Activity: 133
Merit: 10
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 07, 2011, 12:32:21 PM |
|
i run a 4x 5830 rig, sempron 1ram module, hdd. 2x power supplies feeding it all. 620w and a 530w. both 80%+ certified 740 max watts from the wall.
|
|
|
|
Fletch
Full Member
![*](https://bitcointalk.org/Themes/custom1/images/star.gif) ![*](https://bitcointalk.org/Themes/custom1/images/star.gif)
Offline
Activity: 168
Merit: 100
I'll have a steak sandwich and a... steak sandwich
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 07, 2011, 08:43:09 PM |
|
4 x 5850 on Sempron = 620W at wall / 1400 Mh/s
Seems about right. I'm running 3 x 5850 on Sempron and I measure about 480-490 W. I have a 600W 80+ Gold PSU (effeciency 540W) so there's a bit of headroom, but not a lot.
|
|
|
|
newunit16
Member
![*](https://bitcointalk.org/Themes/custom1/images/star.gif)
Offline
Activity: 133
Merit: 10
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 08, 2011, 12:02:44 AM |
|
I have a 600W 80+ Gold PSU (effeciency 540W) so there's a bit of headroom, but not a lot.
people seem to read efficiency wrong. if you have a 1000w power supply rated at 80% efficient, it doesn't allow 800w. it allows 1000w, but it will draw 1250w from the wall. 1250w at 80% is 1000w. you get the power advertised, but the power supply will use X% more, where X is 100-efficiency rating. another note, peak efficiency is usually around 20-75% load on the power supply.
|
|
|
|
blackgold
Newbie
Offline
Activity: 21
Merit: 0
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 09, 2011, 10:42:31 PM |
|
Unit is correct. When reading a power supplies rated efficiency such as 80, 85.. whatever is not shown i.e 100-80=20% is what is lost in the conversion from wall power to make the power... So if your power supply can deliver 1000w @ 80%, then the power from the wall must be 20% greater to make up for loss.
|
|
|
|
johnyj
Legendary
Offline
Activity: 1988
Merit: 1012
Beyond Imagination
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 18, 2011, 03:14:55 AM |
|
I don't really understand ![Huh](https://bitcointalk.org/Smileys/default/huh.gif) Is this mean, if I measured 500W at the wall, the PSU only output 400W to supply the whole machine?
|
|
|
|
macharborguy
Newbie
Offline
Activity: 42
Merit: 0
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 18, 2011, 03:22:29 AM |
|
I have a 600W 80+ Gold PSU (effeciency 540W) so there's a bit of headroom, but not a lot.
people seem to read efficiency wrong. if you have a 1000w power supply rated at 80% efficient, it doesn't allow 800w. it allows 1000w, but it will draw 1250w from the wall. 1250w at 80% is 1000w. you get the power advertised, but the power supply will use X% more, where X is 100-efficiency rating. another note, peak efficiency is usually around 20-75% load on the power supply. good to know, but also reading it wrong is beneficial in a way, since they aren't pushing the PSU as hard as they could be.
|
|
|
|
vapourminer
Legendary
Offline
Activity: 4452
Merit: 3947
what is this "brake pedal" you speak of?
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 18, 2011, 10:46:16 AM |
|
I don't really understand ![Huh](https://bitcointalk.org/Smileys/default/huh.gif) Is this mean, if I measured 500W at the wall, the PSU only output 400W to supply the whole machine? at 80% efficiency, yes. power supplies have "sweet spots" on their efficiency curve, the manufacturer should have a chart. one may peak at 50-80 % load, another at 75-85% load. they vary. but 80+ certified means it will never be below 80% no matter what the load.
|
|
|
|
haploid23
Legendary
Offline
Activity: 812
Merit: 1002
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 18, 2011, 06:25:24 PM |
|
my highest outputting rigs has 3x 5850 and 1x 5870, all overclocked, draws about 750w from the wall using a 850w gold efficiency PSU
|
|
|
|
Morebitcoinsplease
Member
![*](https://bitcointalk.org/Themes/custom1/images/star.gif)
Offline
Activity: 84
Merit: 10
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 19, 2011, 06:00:55 PM |
|
I haven't got the readings but I pull straight from the wall several rigs with UPS battery backup
One setup I have is
(1) Wall Jack handles 7 GPU Cores 1200w PSU with 1x5850 3x5970's
The other is
(1) Wall Jack handles 4 GPU Cores 1200w PSU with 4x5850's
So you should be good pulling from the wall I know I can put 8 GPU Cores on one wall socket on a 1200w PSU
But keeping in mind those rigs are the only items on that entire circuit, I don't plug anything else in them.
|
|
|
|
teukon
Legendary
Offline
Activity: 1246
Merit: 1011
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 19, 2011, 10:20:23 PM |
|
Unit is correct. When reading a power supplies rated efficiency such as 80, 85.. whatever is not shown i.e 100-80=20% is what is lost in the conversion from wall power to make the power... So if your power supply can deliver 1000w @ 80%, then the power from the wall must be 20% greater to make up for loss.
Wouldn't the draw at the wall be 25% greater? If a PSU draws 1250W from the wall and is 80% efficient then it is supplying 1250W * 80% = 1000W to the miner. Honestly I don't know what the efficiency rating on the PSU means but if by 80% they mean that only 80% of the power it receives is passed on then the draw at wall would have to be 1250W.
|
|
|
|
trentzb
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 19, 2011, 11:07:51 PM |
|
Honestly I don't know what the efficiency rating on the PSU means but if by 80% they mean that only 80% of the power it receives is passed on then the draw at wall would have to be 1250W.
Yep, this is what is means.
|
|
|
|
malavita
Member
![*](https://bitcointalk.org/Themes/custom1/images/star.gif)
Offline
Activity: 90
Merit: 10
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 20, 2011, 06:42:49 PM |
|
Does anybody know total power consumption for 5 X 6970 - just cards, not PC obviously.
Thx!!!
|
Somebody's gotta finance this revolution - you can help by donating supplies, ammo, field hospital beds or simply BTCs here: 1QBNASECM8z2LLojkqZH3s2F8Ur7nhafNc
|
|
|
cicada
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
July 20, 2011, 06:52:01 PM |
|
Does anybody know total power consumption for 5 X 6970 - just cards, not PC obviously.
Thx!!!
I can estimate it for you - 6970's pull ~160-200W, so 5x would be somewhere between 800 - 1000W Google + simple math = your friend. [edit][disclaimer] I don't own these cards (I do own 6950s with similar draw), and this is not taking OC into consideration.
|
Team Epic!All your bitcoin are belong to 19mScWkZxACv215AN1wosNNQ54pCQi3iB7
|
|
|
|