Burnside Pool and others not properly reporting my hash rate, LTC

[richtrix]

I'm a noob so I'm stuck here in the newbie section. Here's an image of my cgminer (top) and my burnside's pool stats (bottom). This also happened with coinotron pool and I was using a different machine with them. Can't get my LTC mining to read over on the pool side. What's happening to all of my hash power? As you can see in the screenshot the machine is doing over 2 MHps (LTC) but burnside says I'm only doing like 60 KHps?? I let it run overnight to see if it was just not a realtime stat or something but I checked just now (6hrs later) and it is all the same. It now reads about 120 KHps at the pool which is about 2100KHps off. What is wrong?

http://i42.tinypic.com/293isrc.png

[1714824616]

1714824616

[1714824616]

1714824616

[1714824616]

1714824616

[1714824616]

1714824616

[iANDROID]

You are having a bigger problem with your GPU there. So many HW.

This is why the hashrate is wrong.

[Torn]

See all those numbers under HW.. They are Hardware Errors.. You have settings fugged up.

Re-read the README file in cgminer.. follow directions for setting it up. You should have 0 for HW.

GL.

[richtrix]

what could be the problem...? I used a dirt simple cgminer command script to start with. Didn't tweak anything really once it was open except turning off GPU2. Here is the script

cgminer --scrypt -o stratum+tcp://ltc-stratum.kattare.com:3333 -u VLABlD.1 -p x -I 13 -g 2 -w 256

This rig has been mining bitcoin for about 2 months straight with no issues using BitMinter's JAVA platform and it has been mining with the current GPU settings (via afterburner) for about 3 weeks.... no problems, no crashes.

I have 16 GB of RAM in the machine and 4 7970 with 3GB each. No driver crashes to my knowledge while cgminer was running. I'm switching over to LTC because I have about 12 Giga Hashes of GPU miners and the difficulty of BTC is to the point now that the power cost of the GPUs is making it hard to make any money. I guess the ASICs are finally coming online en mass.

Any ideas on what the HW issue could be? I have the stuff back mining Bitcoin for the moment and, again, working flawlessly.

Thanks guys.

[tstang]

HI Rich,

HW errors are normally caused by the setting is too high or damaged chips.

Try to do normal setting without all the -I -g and etc.

Make sure your Afterburner is set to default or disable it.