Nitro+ 580 8GB ETH ~31.5 Using latest 18.2.2 Adrenanling (Can I do better)

[zoinkydoink]

I am using the following settings using claymore 11

esm 0 -estale 0 -mode 1 -asm 1 -dcri 9 -cclock 1200 -cvddc 900 -mclock 2250 -mvddc 850 -tstop 85 -tt 65 -fanmin 30 -fanmax 60 -r 60

I was getting this hashrate with older blockchain drivers and claimer 10.1

Any of those settings can be improved for better hashrate?

All of my cards are hynix mem and been bios flushed and been set to "compute" mode

[1715439721]

1715439721

[1715439721]

1715439721

[1715439721]

1715439721

[androstan1234]

Maybe use a performance timing instead of copy/paste.

[Metroid]

There is no point doing better than this cause for a performance that you will gain, you will lose on the heat, energy spent side. You must be a noob to ask if you can do better than this.

[whoismoses]

You are already at the max memory clock speed without modding the bios to allow higher. See if you back off on gpu clock by 25,35,45,50,... mhz if that helps at all. Give it about 60 seconds to see if it helped. Sometimes when you are close to the max, the only way is to reduct gpu speed a bit to let it run slightly cooler. However, you should check for memory errors using HWinfo with that memory speed.

https://www.hwinfo.com/download.php

BTW - So what if you are a noob.

[jillscarbrough]

RX580 max 32 MH/s , I think Hashrate 31.5 MH/s is enough if that a stable. On mining, I personal better my RIG a stable than Hashrate a high but not stable.