So I got my nice VESA case today which I plan to use as a wall mount case. In any even, as you can see from the pic below. The pins fall short, and even if they didnt would be exposed.
Sooo, does the below linked item look like it would completely close that gap of and give me a solid connection for my Adafruit LCD ? Not sure how good the pic is but if you can't see it, above the pins there's enough of a gap to take a twice folded in half 8x10 sheet o priner paper and slide it in without moving the LCD much, gap slightly changes based on tension used to hold it for paper test. Basically it comes down to me wanting a solid connection without much if any exposed pin for the LCD.
https://www.modmypi.com/26-pin-gpio-connector-header-extender
