[RESOLVED] Avalon Batch 2 Mini strange behaviour

[MAB]

Hi there,

I've been experiencing some strange behaviour on one of my Avalon Batch 2 Minis when attempting to log into the OpenWRT interface via WiFi.  I am capable of logging in to the device via ethernet (using the ethernet IP address, naturally).  However, when I attempt to connect via WiFi, I get a black screen with the text "LuCI - Lua Configuration Interface" and nothing else (Firefox reports spinning and "Connecting"), and then it times out.

To make matters slightly more confusing, if I plug in the device via ethernet, and attempt to access it via the WiFi IP address, I connect just fine, and additionally, when I attempt to log in with just the WiFi and no ethernet connection, if I plug the ethernet cable in while Firefox spins and says, "Connecting", it'll immediately connect.

Any thoughts?

Thanks,

MAB

[1715540848]

1715540848

[1715540848]

1715540848

[zulover]

Perfectly normal.you can connect over wifi with ethernet cable being used.one or the other only. Belive I did it on 16 of them.

[Bogart]

Do you have the interfaces bridged?

Is the avalon wifi set to AP mode, or is it in client mode and set to connect to some other wifi AP?

Personally I only use ethernet for all my miners, avalons and otherwise.

[MAB]

Thanks Bogart, that seemed to be the issue.  I have now resolved it and I went through the configuration of two devices (the one with strange behaviour and another which was chugging along just fine) and that was the issue. A quick change and a hard reboot solved it.  Thanks!