RPC username and password

[anusha5678]

How can i find RPC username and password in electrum

and how will i config

in my code?

[1715176978]

1715176978

[1715176978]

1715176978

[1715176978]

1715176978

[1715176978]

1715176978

[1715176978]

1715176978

[1715176978]

1715176978

[bob123]

You can't 'find' your RPC username and password, you have to set one first.

In the console (to set port, username and password):

Code:

electrum setconfig rpcport 7777
electrum setconfig rpcuser "username"
electrum setconfig rpcpassword "password"

Then start the daemon and load your wallet file:

Code:

electrum daemon start
electrum daemon load_wallet

[anusha5678]

how i will start daemon

i did set rpcuser and pass and port. next i willl put this command create() , its shows error msg and also tried daemon command , how can i start daemon ?

https://prnt.sc/j9ck81

http://prntscr.com/j9ckfk

please check this screenshorts.

[bob123]

You need to run this commands in a command line, not in the electrum console.

The required steps are outlined in this guide: http://docs.electrum.org/en/latest/merchant.html
This guide is based on a linux system. Commands on windows might differ from them.
Anyway, it is recommended to run a webserver on a linux machine (for security reasons).

[HCP]

This guide is based on a linux system. Commands on windows might differ from them.

Commands on Windows don't exist as there is no Electrum daemon for Windows... and you cannot use commandline options like you can use on Linux.