Blade Erupter 2.01 issues

[Phyir]

Hello, I've followed all of the guides on here I could find to set my blade up. Got power, and I "assume" it is mostly working because it resets every like 2 min. My issue is that I can not get to the setup page at all. no IP address seems to work whether it is connected to my gateway or directly to my computer itself. Any help would be immensely appreciated. Last guide followed was Dogie's Comp guide. just can not get the set up going at all. Thanks again

[ldh37]

the default for the setup page is 192.168.1.254:8000/main.  check the default gateway on your pc - if it is not 192.168.1.x then you will need to change it to connect to the blade the 1str time.  connect the blade to your pc and change the gateway on your pc to 192.168.1.1 and the IP to something like 192.168.1.200.  you may need to reboot the pc after changing the IP.  then use the default setup IP (192.168.1.254:8000/main) to connect to the blade.  then change the blade gateway and IP to match your network.  e.g., my network gateway was 192.168.0.1 so i had to change the blade to match that and then give it an IP on my network (192.168.0.200).  then i was able to connect the blade to my switch and access the setup over my network.  of course you also need to set your pc network settings back to normal when done.  the following link shows it but don't set your pc IP to the exact same as the blade as in the picture.  http://www.fadishop.mobi/bitcoin/blade_ini2.pdf

[Phyir]

Ok, so amazing. got to the setup page, but I might have set an invalid ip to connect to. I had it set to 10.0.0.20, but thought it was too close to some others so i set it to 343.  is this number invalid, it wont let me connect to it anymore. is there a way to reset?

[ldh37]

the following image link shows where the reset pins are.

http://www.asicminer-shop.de/wp-content/uploads/2013/09/AnleitungBladeNeu.jpg

[caminilegroup]

Ok, so amazing. got to the setup page, but I might have set an invalid ip to connect to. I had it set to 10.0.0.20, but thought it was too close to some others so i set it to 343.  is this number invalid, it wont let me connect to it anymore. is there a way to reset?

It shouldn't have let you set it to 343. Ip range is 0-255, usable 1-254, 0 & 255 are not usable as they are reserved for network functions.