 |
December 30, 2013, 11:32:47 AM |
|
Hi, I have just overclocked one of my usb asic miner v3 and when I connect it to the usb, the led does not light up or recognized by the pc. the BE100 chip gets hot
Im using a 16 mhz oszillator and 1.2K on R1
I re soldered the crystal and checked for the direction and it was good. I also re soldered another resistor just to be sure, but its still not working.
I have tested it on a power supply which could go up to 5A, still the same thing.
Someone told me to measure resistance between the VCC and GND and it was 0.5ohms while on a working one it was 7.3ohms
What could the problem be (im thinking its the CP2102- its the one which handles the power, yes ?)
Any help would be much appriciated
|
