D9 IP inactive

[Shane2821]

Why does my D9 IP show inactive. I can't log in to do any changes on the settings. And if the ip turn active it's only for a few seconds active. It don't let me saved any changes. I am running other miners also and they all run without problems on my network. Any suggestion. Anybody had this problem?

[chris-swiss]

hi, sorry for you,
changle the ethernet cable to control and update the software maybe it will fix your problem.on innosilicon you can update the firmware
you can go to your modem to see ip

[Shane2821]

I cant do updates cause i can't log in miner ip to do that.  Iv tried different cables. Same problem still.

[chris-swiss]

I cant do updates cause i can't log in miner ip to do that.  Iv tried different cables. Same problem still.

go to your modem for checking ip its connected , and if don't work i think use reset button to left your ethernet entry on asic . sorry for my english i hope its finish good .
you can download on innsolicon the manual d9

[Shane2821]

The modem picks up the miner IP but its not in an active state(no connection) so i cant do anything if i cant log in into it. Even after reset still the same. Can the control board be faulty with no red fault light flashing.
 

[chris-swiss]

sorry for you , i think you send an email directly to innosilicon for check that .veery strange i hope you d9 working soon for your ROI.
you have test ip set button its on left to entry ethernet cable after you have reset your asic

[Shane2821]

Finally i solved the problem. My Network switch was the problem. Thanks for everybody's input and help.

[chris-swiss]

great for you happy mining