MEW problem

[chenhaonan]

My transaction have not gone through for a day. After checking status they were not found but I waited. Gwei was set to fast. Tried sending again but it wasn't allowed. It takes days now or what is the problem?

The network is very crowded and you should adjust Gwei. This number must be greater than the value you used when you last transferred. And you have to make sure that your other wallets don't use the value of this Gwei. You can check your wallet and try this method.

[CrashGangster]

As far as i know current ETH network position is good but someone says network goes down that’s why they changing the exchange. I hope situation will be alright.

[TheBitcoinBadger10]

I think you are facing situation because of the congested netwrork.it is known to all the price if this eth is decreasing and so people are selling eth and so the network has become very much congested. You can either pay high or wait for few days for solving such problems.

[jackpot888]

Actually this is due to network problem as we know that Eth network is not very much developed and the recent low price has many investors to sell their investment as a result network has become congested due to huge transaction. So keep trying or do wait for some day.

[dreammoney710]

A lot of people had this sort of problem before too. They waited a little and then it was fixed. This mainly happens when the network gets congested. There is nothing to be worried about.

[giletto]

My transaction have not gone through for a day. After checking status they were not found but I waited. Gwei was set to fast. Tried sending again but it wasn't allowed. It takes days now or what is the problem?

Sometimes I also encounter this case. Someone with bad intent makes the ETH network blocked by transaction spam. It causes the entire system to be delayed and requires very high gas levels if no delay or simply too many transactions occur at the same time. So you can try again later in the day or increase gas

[Woodpecan]

In my opinion the speed of this is depends on the amount of gas element that one should give. The more gas one give the more faster transaction will executed.

[Rrtt]

My transaction have not gone through for a day. After checking status they were not found but I waited. Gwei was set to fast. Tried sending again but it wasn't allowed. It takes days now or what is the problem?

I don't know the real situation of your MEW but i have experienced that one too and the fix is i used Metamask where i export the private key to Metamask and i made my transaction, everything is ok since that one.

[aldorexxx]

MEW is getting weaker because there are so many problems now and I am sure that their amount will be larger. It needs to be corrected or it will be on the bottom.

[kazakovv]

I never had problems with it of a purse. All quickly and reliably. I will use it in the future. Everything suits me. I recommend

[tamango]

yesterday i moved some tokens from mew to another wallet without any problems with standard setup gas/fees in mew, so it's strange. Are you sure you didn't modify gas price and set a lower one? If you have still problems try to use another wallet like NOKU, I prefer it to MEW because it reads also automatically tokens without need of manually adding them.

[yayat]

Check the GWEI and GAS limits because from there we can see which one is the fastest to send.
I also tried with Gwei 40, GAS 50,000 but it was not sent, then I tried GWEI 50 and GAS 100,000, the results were sent.

[NewBet]

Never had any problems like this, you need to check and make sure that your gas did not run out and set a higher gas for the transaction. Also remember that if you are transacting tokens then it takes teh wallet more gas than normal to transact than if it was an eth transaction so check that. Also make sure that you are sending it to the correct address

[MikeyVeez]

My transaction have not gone through for a day. After checking status they were not found but I waited. Gwei was set to fast. Tried sending again but it wasn't allowed. It takes days now or what is the problem?

Show us the transaction on etherscan.
Did you send Ethereum coin or some ERC-20 token? What was the final fee for the transaction? Maybe, it wasnt allowed due to smart-contract (if you are sending token ).