Hi guys.. I have a problem here and I hope you guys can give some advice. I just installed my M20s 4 days ago... it was running fine at first but after around 14 hours to 16 hours... it fluctuates and the hashrate keeps dropping and on and off by itself a few hours and then it runs again... it has been like this for these few days already. Sometimes it shut down and I reboot it to start again. Anyone facing this problem before? Or am I unlucky to get a faulty miner
hard to say.
do you check fan speeds and temps?
if fans are doing over 6000 rpm and the gear is over 75c the room could be too warm.
these are power hungry units.
do you use proper cables?
is your power 210 volts or 220 volts or 230 volts or 240 volts. or worse yet do you sag to 195-200 volts?