Innosilicon T2T 30TH problem

[Shaqovic]

Hello

So I finally finished setting up my farm, 40 T2T units installed, For a week started mining no issues and then first unit got Error code 35 then second unit also, now I can't use both units with Error 35 ( PSU_LOW_VOLT.chain(2).chip().msg(GP 8.66 2048).

Would really like some help from you guys.

Thank you in advance

[BitMaxz]

I just got an answer from the other forum while searching on Google according to them you need to flash the miner to the latest version.

You can download the latest version from innosilicon download support.

Link from here https://www.innosilicon.com/html/support_en/download.html
Just make sure to download the right firmware for your miner.

[Shaqovic]

Thanks for the reply, I already Updated the firmware to the latest version, but still giving the same error.

[BitMaxz]

If it doesn't work try to read this link below.

- https://www.innosilicon.com/html/support_en/q_a.html

You can find the answer under "How to locate the faulty part by the error code of the miner?" If their solution doesn't solve your issue you might need to replace the power supply or send it back to innosilicon for replacement or repair.

Maybe the firmware version you flash might be incompatible for the PSU of your miner that is why you get this error.

Do you have a miner tool installed on your PC(On the same network)?

Try to use inno monitor tool and do this step to check the PSU vendor, PSU version and errors.



the InnoMonitor can be download from here https://www.innosilicon.com/html/support_en/tool.html

All the guide is under their faq page. You need to read this "How to update T2TZ-30T or T2TS to the latest firmware?." It might help to troubleshoot the problem if you get the PSU vendor and PSU version post it here I try to help you find the right firmware for your miner.