WTS 3 individual L3+ Hashboards - 2 good, 1 bad

[fyoung55]

One board is bad. It's recognized, sometimes says 72 asics, sometimes 6 asics, most times 0 asics.  It wasn't the controller as I swapped board and everything ran fine.  Maybe someone has use for the individual chips or can easily fix what's wrong.

Second board is good.  It has the larger round capacitors on the back.

Third board is also good.  It has the smaller rectangular capacitors.

Shoot me a message or offer for 1,2 or all 3 boards.

[MoparMiningLLC]

before I waste time in PM's - where are they shipping from? and do you have a ball park figure? I have a couple L3++'s that could use replacement boards. But not looking to spend a fortune as the miners themselves are fairly cheap.

[fyoung55]

Thinking maybe $20 a piece for good ones, but bundling will save on shipping

[offordscott]

$20 for a fully working L3+ is appropriate in today’s market.

[MoparMiningLLC]

just realized, I dont have L3+ --- I have L3++'s would it be bad idea to mix boards from these two versions? from my understanding/memory these are the same chips just the L3++'s got a bit better quality, thus faster, chips.

[fyoung55]

 I know you can flash l3++ firmware onto l3+ and it runs fine, so probably, but I can't guarantee it.  Anyone else know?

[Philipma1957cellphone]

I know you can flash l3++ firmware onto l3+ and it runs fine, so probably, but I can't guarantee it.  Anyone else know?

L3++   are simply better binned chips they should work but as we found out flat cap boards and round capped boards may not fit in the same unit.

So @ mopar take screen shot of your boards back and front match with fyoung boards.

[fyoung55]

bump - any interest?

[MoparMiningLLC]

sorry had a lot going on and have not had time to take one apart to look at. will try to do it this weekend. they are borderline profitable so not even sure if I should sink more money into them or just look for the inno A6 - a bit more profitable. actually got lucky and got one for $100 shipped off of eBay. but havent seen any more

I will take one apart and see this weekend.