I ve got Electrum but i think i imported wrong...I dont see anythink in electrum
Were you able to restore from the mnemonic code in such a way that you were shown a "wallet" with addresses, and an (empty) transaction history?
If this is the case, can you then confirm that these addresses start with the same letter as your "old" addresses where you send funds to?
If not, the issue might already be found.
When restoring from the mnemonic code, choose BIP39 (which you probably already did) and choose the correct script type according to the first char(s) of your address:
- "P2PKH" to restore addresses starting with 1..
- "P2WPKH-P2SH" to restore addresses starting with 3..
- "P2WPKH" to restore addresses starting with bc1..
If on the other hand you have already chosen the correct script type, can you verify that electrum is connected? Do you see a green circle in the bottom right corner?
Further, since you are talking about multiple "subaccounts", you might need to change the derivation path when restoring from the mnemonic.
This means, when restoring and choosing the script type (see above), you might need to change the derivation path by increasing the last digit:
For native segwit (p2wpkh), this would be:
m/84'/0'/1' instead of
m/84'/0'/0' for example. Depending on the amount of "subaccounts you might want to increase it a few times until you have found the correct path.
In short:
Please check that electrum is connected.
Afterwards check with what char the addresses should start with (by looking at your old transactions or addresses) and choose the correct script type.
As the last step, increase the last digit of the derivation path.
P.s. Be careful with people PM'ing you.
Try to keep it as public as possible and don't give away any sensitive information.