Antminer S17e's strange problem

[jonaeljoni]

I updated costs via finnish postal service. It's only 70 euros for normal shipping and shipping time 6 to 14 work days. Faster option is 80e and shipping time only 2 to 8 working days.


Okay update:

NOTE:
The repaircenter in the Netherlands has been closed recently. This means from now on repairs need to be send to the repaircenter in Hong Kong directly by you. The adress will be given to you after you have created a ticket.

You will have to pay for the shipping fee to Hong Kong. The repaircenter will pay for the shipping costs back to you.


So it will be afterwards free for me.

[1714965569]

1714965569

[1714965569]

1714965569

[1714965569]

1714965569

[jonaeljoni]

Code:

2021-01-23 11:11:32:driver-btm-api.c:2379:bitmain_board_init: FAULT: check_asic_number_until_volt_balance PASS but bitmain_board_config_init FAIL!!!

There are a few things I would check, the first one would be the PSU, power off-chain 2 and 3, this will confirm if the problem is a bad PSU (a very common issue) or your Chain 1 has other problems, once that test is done, if the PSU is fine and the board still shows 0 frequency and hashrate, your next move would be changing the tunning profile, what is your profile settings as of right now?

On a side note, BinancePool sucks.

How can I change those tuning settings? Or is it wise now? I can try to find information tuninging it up

[favebook]

You would have to upgrade it to a custom firmware, like Thierry's one I linked previously.

But if you do that, please revert back to original one before sending it to Bitmain as it is not covered under warranty.

[jonaeljoni]

I recovered control board with sd file. I got it from Bitmain's customer service.

Now the whole miner isn't working. So frustrating.

Before it showed that invalid volt etc. but worked with two hashboards. After driving sd file none of hashboards arent working. Kernel log says something about temp sensor's type.

I think this is a crucial moment when I will send this to warranty repair.

Code:

2021-02-22 10:59:34 power_api.c:274:set_working_voltage_raw: working_voltage_raw = 1850
2021-02-22 10:59:35 temperature.c:297:calibrate_temp_sensor_one_chain: chain 0 temp sensor NCT218
2021-02-22 11:00:30 temperature.c:219:is_temp_sensor_type_correct: Wrong temp sensor type, chain = 1, sensor = 107, type = 0x0, retry.
2021-02-22 11:00:30 driver-btm-api.c:186:set_miner_status: ERROR_TEMP_LOST
2021-02-22 11:00:30 driver-btm-api.c:127:stop_mining: stop mining: Can't get temperature sensor type!
2021-02-22 11:00:30 thread.c:750:cancel_read_nonce_reg_thread: cancel thread
2021-02-22 11:00:30 driver-btm-api.c:112:killall_hashboard: ****power off hashboard****

EDIT: I upgraded firmware and now it is working again with two same hashboards as before. So sending to China for warranty repair is not compulsory  right now. I will do it later. My warranty expires end of this year. Miners bought from antminerdistribution gets warranty of two years. So I have time left.