what voltage and freq for t17e hashboards

[moritezza]

hello.

what is best voltage and Frequency for hashboards of t17e? i want set manually.

screenshot: https://prnt.sc/ydpq3h

i set below volt and freq, and it seems is cool, its fine? or its not good?

screenshot: https://prnt.sc/ydt2ua

Thanks.

[danieleither]

Which firmware is this?

[BitMaxz]

According to his image, the design looks like a custom firmware from asicfw.io.

Here's the full page of the advanced settings on asicfw:



If you are going to use this firmware take note of the dev fee according to them it's around 1.3-2%. This is not a well-known custom firmware and this firmware mostly promoted on the Awesomeminer page/thread.

[mikeywith]

Your 3rd hashboard (Chain 2) looks like it could use some extra voltage, but since you can't specify voltage to a certain board, you would either reduce its frequency or increase the voltage to all of the hash boards.

Keep in mind, these miners are different, the best tuning for your miner is unlikely to be the same for someone else's miner, some boards have some lucky chips that can be perfectly tunned, some will drop with the slightest voltage drop, find what works best for you, you want low temp, no xxxx showing on the status page, no hardware errors or a ton of rejected shares.

I also noticed this firmware reports over 9500 RPM for the intake fans, which can't be the case, I don't think I would trust this firmware.