Innosilicon T2THF 30TH

[Antihackme]

Hi everyone,

I just got my mining farm up. All the rigs are currently in performance mode +0.

Will this spoil my rig in the long run? Anyone used performance mode +0 and manage to have their rigs last a long time?

And also i found 2 rigs with only 2 hashboard working each. What is the best way to repair this if my farm is located in thailand?

Are there any good video guides out there on repairing hashboard and getting new wires?

[BitMaxz]

According to this https://www.zeusbtc.com/Repair.asp
They have a repair service in Thailand if you want to take their service you can contact the team on their email below.

Email: repair@zeusbtc.com

Or check this link below for hashboard repair guide.

- https://www.zeusbtc.com/NewsDetails.asp?ID=176

[Antihackme]

Hi bro... thanks alot for the valuable information!

Btw what is the recommended settings for t2t mining rigs? eco or balanced? and +0 or + 2?

[mikeywith]

Btw what is the recommended settings for t2t mining rigs? eco or balanced? and +0 or + 2?

It all depends on what you are trying to achieve and obviously your power rate, if the cost of electricity is too high then eco will be a winner in most cases, even with the lower hashrate you get since eco improves the gear's efficiency, if you think the difficulty is going to spike and you want to maximize your gains now then you might want to overclock the gear and go with the +/performace settings, everyone has a different sweet spot for tuning their miners if it was up to me, I'd just keep the factory mode.

[Antihackme]

Performance is - 2400w. i can't seem to find the power of the other modes possible to let me know whats the power for factory/balance/eco?

I currently have 35 rigs in a shophouse and performance mode seems to be over limit of the entire place. So I am trying to find the electrical power of the rest of the modes.

anyone know how to fix error code 2048 psu error?