Hello,
i have one hash board which have a bad frequencies.
Log is without failure.
Used firmware HiveOS .
Here is explanation:
When is a hash board in Chain 0, problem is with line 4. When i insert board to Chain 1, problem is with line number 3.
I dont understand. :/ is it mystery for me. What sets up the frequencies for lines/Asics ? What do these lines have in common?
I changed 2x 0,8Volts and 1,8V regulators for line 4, next i changed first and last asic chip in the line, but same issue, after 5 minutes are Asics in line red.
Check picture
![](https://ip.bitcointalk.org/?u=https%3A%2F%2Fimgur.com%2Fa%2Firei6WZ&t=664&c=q4fF-nZfl1upYA)
Thank you for help.
M.