Hello all,
These 15w pads are expensive and kinda hard to cut and make use of this super small sheet (90mm x 60mm) in a way which i have zero waste from this expensive pad. Assuming I have to replace all pads on the entire card, i went ahead and purchased a few of these in a few different sizes. All cost me around $50 and a WHOLE lot of time to replace the pads.
So, all pads seemed to be oily but there were certain pads that I think didnt really need replacing, like on the SMD resistors/inverters, let alone with a 15w pad. Is it common practice to replace ALL pads with the same pads? or would I be better off replacing just the mem and ram with these 15w pads?
Use 15w pads for memory only, and for SMD resistors/inverters, use inexpensive 3-7 watt pads.
Look at the quality of SMD resistors thermal pads. If they are in good condition and do not leak liquid, do not replace them.