Whatsminer firmware

[mbw0i777]

Hello everyone! Lately, I've been noticing a lot of custom firmware for Whatsminer. Does anyone have any information on how this is done and if it's possible to create your own? If you have any information about this, please contact me.

[1714680331]

1714680331

[1714680331]

1714680331

[1714680331]

1714680331

[1714680331]

1714680331

[BitMaxz]

I never heard that there is custom firmware for any whatsminer units even Braiins, awesomeminer, and Hiveon OS do not support it.

Where did you find that there is a custom firmware for whatsminer?
I'm sure that's a scam or infected with a virus if it was from an unknown source.

[Sledge0001]

I haven't seen or heard anyone either writing custom firmware for that whatsminer(s).

You can however get a glimpse into their API here: https://www.whatsminer.com/file/WhatsminerAPI%20V2.0.4.pdf

[mikeywith]

Unlike what the two fine gentlemen above mentioned, there are actually two known custom firmware for Whatsminer, Chipless, and Bixbit, the main problem with these firmware including everything else that might come out in the future, is there is actually no reason to run them and pay high fees.

The stock firmware offers most of the features, you can overclock, underclock, set power limit, and submerge your miners using nothing but the stock firmware, and since using custom firmware requires a lot of trust, it's pretty difficult to find enough reviews from people who use those custom firmware versions, so most people are skeptical about using them especially that "again" there is really no use case.

[maxfunky]

is there a way to control fan speed of a whatsminer ?

[BitMaxz]

is there a way to control fan speed of a whatsminer ?

No, it does not have a fan control even using their API you can't able to edit the fan speed but you can retrieve RPM speed through API using the Whatsminer tool under remote control.

If you plan to reduce the fan speed maybe switching the settings to low power mode might help to reduce fan RPM.

Or if you plan to cool down the miner a bit you can modify the miner's frequency through API.

[philipma1957]

is there a way to control fan speed of a whatsminer ?

not a good idea. I have eight units
 2x m10
2x m30
4x m50

all of them have hot exterior that is deliberately done.
all of them are long with larger fans
only two fans that do about 310cfm each
with the long length heat sheds to outside walls of the miner.

If you want to reduce fan speed try two long heat sinks on the left and right outside of the miner.

thus the ability to shed heat on those walls would lower internal heat.

[mikeywith]

is there a way to control fan speed of a whatsminer ?

Using the stock firmware, no.

however, there is really no reason to adjust the fan, after playing with hundreds of Whatsminers I released that the fan speed is handled perfectly unlike many Antminers ( the stock firmware to be exact). if the fans are running slow and you think the miner is getting hot, you are wrong, the miner is at the temps it wants to be at, and the same thing goes for the opposite side of the story, if the fans are running too fast, they are keeping the miner at the temps where they think it's safe.

I understand you might want to adjust that on Anminter since based on my own experience all those s9s, T17 and S17 had some weird fan/temp ratio, but this isn't the case with Whatminers, in fact, I think even the custom firmware I mentioned above don't allow that, the fans can be unplugged and you tell the miner that it's going to dive into a tank for immersion cooling (it will stop checking for fans), or you let the miner control them.