Bitman S19 Pro hydro - spare hasboard

[Beny44]

Hey. Hey,

my S19 Hydro 180 chips board is gone. i can't find a shop where i can get a new one.
Anyone have a tip?

Thanks

[1715240814]

1715240814

[1715240814]

1715240814

[1715240814]

1715240814

[1715240814]

1715240814

[1715240814]

1715240814

[1715240814]

1715240814

[CochnocherCrypto]

gone - as in totally dead? physically damaged? or does it just have 1/multiple bad strings of chips hindering the board?

The board may be repairable... but if it's not, I would reach out to AltairTech (have personally purchased tons of miners/parts from them over the past 4-6 months, if you're in the USA - you'll get everything FAST!) or MineFarmBuy and see if they are able to replace the board if you're certain that it's irreparable. Both very trustworthy vendors who offer parts for those machines.

Best of luck!

[Beny44]

She's not quite dead. 
It is visible in the system, it just does not see any chips.  I tried to connect to another data line but it was the same.  I have already made an appointment with us for checking and rewriting.  I'm from the EU.

[Beny44]

But what bothers me is that sometimes it ends up with an error, see  code.  I don't know what it can do.  And it's randomly on all boards.  The temperature is good, but today I heard that every chip is not reporting the temperature.  That there are only three sensors.  Then I wouldn't know how the plate is somewhere in the middle.

Code:

  [2024/02/21 08:05:38] INFO: Setting voltage to 20220 mV
[2024/02/21 09:14:12] ERROR: Could not read register = 0x0 from chain = 0x0 chip_addr = 0xB3! /chip.c:567/
[2024/02/21 09:14:12] WARN: chain#1 - chain break detected
[2024/02/21 09:14:15] WARN: chain#1 - actual volt 19936
[2024/02/21 09:14:15] INFO: chain#1 - powering off the chain
[2024/02/21 09:14:16] INFO: Shutting down the miner
[2024/02/21 09:14:16] INFO: Setting freq to 50 Mhz gradually/code]

[BitMaxz]

But what bothers me is that sometimes it ends up with an error, see  code.  I don't know what it can do.  And it's randomly on all boards.  The temperature is good, but today I heard that every chip is not reporting the temperature.  That there are only three sensors.  Then I wouldn't know how the plate is somewhere in the middle.

What do you mean it's randomly on all boards? Do you mean in all hashboards the error comes up?

Did you already did some basic things to do first before you decided to replace the hashboard?

I suggest flash the unit first with the latest firmware and maybe it is just a software bug. If it does not work try to flash the unit through the SD card.

If it still does not work try to run the unit with only one hashboard and check them one by one if they are working fine there might be an issue with the power supply maybe it can't give enough power to run all hashboards.
However, if the one hashboard is not working as your said then focus on that hashboard if you don't have technical knowledge to repair then you don't have any other choice but to buy a replacement.

You can try contacting Zeusbtc sales on their Whatsapp # +8618623251355 or sales staff email faye@zeusbtc.com they might have a spare hashboard for this unit.