BitAxe Gamma 601 - 100% Hash Error Starting Firmware v2.14.1 & v2.14.2

[ohio_jaunt]

I have done about everything in the book, and flashed all of these Bitaxes (3x), but they refuse to connect to my Umbrel.local node and show any hashrate whatsoever.  Any ideas?

Originally, I thought it might be my ASUS router, but everything that COULD be a problem has been disabled now, and it was working for years previously.

Any idea why the system would work for years, and now all of the sudden, refuse to hash whatsoever on my solo node?

[ohio_jaunt]

Umbrel.Local seems to be the issue, because the errors return normal when I set my Pool to "public-pool.io"

Has something changed recently that affected the Umbrel node systems on a local configuration?

Does anyone have any insights or idea?  It was working normally for years, so I have no idea what could have changed.

[FP91G]

There's an old rule: if the hardware is working perfectly, there's no need to change the firmware. If you decide to change the firmware, do it on one device for testing. After checking functionality, change the firmware on the remaining devices.

Is it possible to publish the logs?

[ohio_jaunt]

Yea, noted, but I'm not even sure if the firmware update is the precise cause.  It seems to be working fine on Public-Pool.io, but I'd like to use my node if possible...

Nevertheless, how do I attach my log file to this forum?  It doesn't seem to accept standard attached files.  Can I email it?

[FP91G]

Yea, noted, but I'm not even sure if the firmware update is the precise cause.  It seems to be working fine on Public-Pool.io, but I'd like to use my node if possible...

Nevertheless, how do I attach my log file to this forum?  It doesn't seem to accept standard attached files.  Can I email it?

You can use any online service for txt files or publish logs on this forum using the tag

Code:

If the log is too large, it's better to use online services. I'll look at the log and send you a response. Did your custom mining pool work on the old firmware too?

[BitMaxz]

Maybe the Umbrel.Local is refusing to connect to BitAxe.

How do you set up your BitAxe? What URL do you use? Did you just put umbrel.local on the pool URL, or did you put a local IP? Without Stratum protocol?

The logs should give you hints. You can post them here using code tag or follow the FP91G instruction above.