Antminer S1 got shot

[Scuboven]

I had 3 antminers running connected to two Iball Extension boards with 4 slots each

i had 3 antminers they were running good with no problem

Then i got two machines more i connected them

and went outside with my freind for 2 hours i came back and everything was off

the two extension boards probably got shot so i reapired them they are working now

but those antminers just blinking light

i think antminers got shot

i tried resetting the antminer via the button

Please tell what to do http://

[klondike_bar]

-your language is a bit confusing. heres what i understand:
-you had 3 machines running on two iball extension cord/bars.   (Presumably on the same duplex outlet?).  It worked without a problem (about 1250W power draw considering PSUs)
-you added two more machines (another ~800W).    Total of 2000W  (or around 17A of 120V).

Sounds like 1 of two things occured:

1) the extension cords can only handle 15A and they popped. Its possible your circuit panel also popped if it was a 15A outlet.  (If it was a 20A it might not pop, but would be loaded near the limit and any other lights/applances on it could push it beyond safe limits (should never have 24/7 load over 80% of circuit rating)

2) your PSUs cant handle the antminers the way they are setup. They trip when the antminer starts hashing at full power draw, and a few seconds later turn back on and the ants reboot, start hashing, and trip the PSU again.

[Soros Shorts]

i think antminers got shot

What caliber? If .22LR you might be able to fix. Anything larger probably not a chance.

[Chris_Sabian]

Check the circuit breaker in the house first.

[helipotte]

i think antminers got shot

What caliber? If .22LR you might be able to fix. Anything larger probably not a chance.

Probably birdshot.

[xingqiaoyin]

LOL
Probabaly another BFL shill they seem to have been making themselves look good by playing down bitmain recently.

[GaryL]

I think you should contact the reseller first!~