CPUMINER and G-Blade problem

[SUGO]

I have a rig with a g-blade and 7 gridseed. I tried for first time CPUminer, but after a couple on minute an half of g-blade don't show any accept or reject lines (coloured lines)... It show only white string il loop:

New job id ...
Stratum detec new block
Dispathcing newwork on...

It means it not mining right? But the question is: why? I divide thw works in 3 session of cpuminer (one for the 7 gridseed an 2 for the 2 half gblade), and only an half of gblade give this error (with all frequency set)

I'm using cpuminer beacouse is the only miner with autoclock, right? Or there are some others?
The problem is beacouse the 2 half gblade must run both?

[kingscrown]

http://fuk.io/gridseed-g-blade-vs-gawminers-cloud-hosting-comparision-and-review/
check my guide

[coincidenter]

I had a similar issue running cgminer on Windows 8.1.  Not sure it's the same thing you're seeing, but this is what fixed it for me:

1. Disconnect your GridSeed Blade USB from your computer.
2. Run cgminer (or in your case cpuminer).
3. Plug the USB back in.
4. Wait a few seconds and you should start to see the usual accepted/rejected lines.

I'm assuming you did the Zadig WinUSB driver install step before all this.

[sandor111]

I have a rig with a g-blade and 7 gridseed. I tried for first time CPUminer, but after a couple on minute an half of g-blade don't show any accept or reject lines (coloured lines)... It show only white string il loop:

New job id ...
Stratum detec new block
Dispathcing newwork on...

It means it not mining right? But the question is: why? I divide thw works in 3 session of cpuminer (one for the 7 gridseed an 2 for the 2 half gblade), and only an half of gblade give this error (with all frequency set)

I'm using cpuminer beacouse is the only miner with autoclock, right? Or there are some others?
The problem is beacouse the 2 half gblade must run both?

Make sure that you are running the latest version (1.0d), apparently this issue has been fixed lately.
https://github.com/siklon/cpuminer-gc3355/