Dear colleagues and Miner.eu
When I switch the A2 new mini on, and open your scripta interface, both blades are mining normally. However, in about 30 seconds, their hash rate begins to decrease and reaches 0 (zero) in 20-25 seconds. And stays there indefinitely. Restarting the miner does not help, neither does rebooting Raspberry. Only if I physically turn the power supply off and on again, the blades start working, but everything happens again like I described in the beginning.
Please, help.
-------------------------------------------
21/09/2014
I sent almost exactly the same text directly to Miner.eu yesterday. Received an answer today:
-----------
Hi,
You could search youtube to find some instruction of setting up the miner.
https://github.com/MinerEU/scripta_a2It is our image download link for the miner, please check this out as well.
good luck!
--------------
I wonder, do they read their customers' mails at all?
I sent another mail - quote below:
--------------
Dear Support.
1. There are no videos depicting the setup of A2 New Mini Terminator with Raspberry PI built-in. None. Not on YouTube, not anywhere.
2. As I have already mentioned, I installed your Scripta miner and interface using CURL from Raspberry. Successfully.
Let me, please, specify the problem again.
1. A2 New Mini Terminator is powered correctly.
2. Immediately after power-on, when Raspberry loads, your Scripta interface shows that both blades are working normally.
3. In 30-35 seconds, hashing rate on both blades starts to decrease.
4. In another 30-40 seconds, both blades come to zero.
5. Miner restart or Raspberry reboot does not help.
Could you, please, help. I can execute and send you results of any log outputs, grep - whatever you need.
Regards
--------------